Skip to content
[4-2-1-2] Direct Connect
Quake

[4-2-1-2] Direct Connect

Configure Quake direct connect settings: COM port, IRQ, and baud rate (9600-57600). Connect to another computer.

By ···10 min read·Multi-source verified
1 reading this guide  

Configure Quake direct connect settings: COM port, IRQ, and baud rate (9600-57600). Connect to another computer.

To set up a direct connection in Quake, you will need to configure the following settings:

Port: Select the COM port (a communication port used for modems) that your modem is connected to.

IRQ: This setting (Interrupt Request line) will automatically adjust when you change the 'Port' setting. It is recommended not to change this manually unless you are experienced.

Baud: This refers to the baud rate of your COM port. The minimum baud rate is 9600, and the maximum is 57600. Higher baud rates are not always superior.

Connect: Select this option to initiate the connection to the other computer via a direct connection.

Tips
  • Do not alter the IRQ setting unless you are certain of what you are doing.
  • Experiment with different baud rates between 9600 and 57600 to find the optimal setting for your connection.

100% Human-Written. AI Fact-Checked. Community Verified. Learn how AntMag verifies content